First impressions is everything! Show the world that you're not afraid to show your inner demon with this quick print for that board meeting, job interview, first meeting with girlfriend/boyfriends parents or even as everyday casual wear or a fashion statement.

For wannabees, also suitable as a costume for parties and Halloween.

Recommend printing the hairband in PETG rather than PLA as it is more flexible and therefore more comfy to wear. Also would recommend plenty of layers instead of infill for extra strength and flex.

There are two types of horns. One is very pointy and could actually hurt someone if not careful (better choice for demons). The other one has a rounded tip. Use this option as “training wheels” or for kids. Color of choice, but red/deep red will of course give you nods of approval in the right circles. PLA is fine. Oh, and remember to print two of them as they are the same on both sides.

The bottom of the horns are curved, so print with supports from print bed. Mind the hole so it doesn't fill up with support and become a nightmare to clean up afterwards.

Horns should fit snugly onto the pegs on the hair band. Results might vary with choice of filament and printer calibration. A dash of glue might be prudent. Would not recommend dropping the hear band and gluing directly to head.