Added some recesses for 2mm magnets (2 for the small, 4 for the med and large) to srwilson58's original clip. These work great for chips, candy, or just about anything else. Adding the magnets allows mine to be stored on my fridge for easy access.
Original designer https://www.thingiverse.com/thing:1212828
I used these magnets from Apex https://www.apexmagnets.com/magnets/2mm-x-2mm-cylinders-neodymium-magnet
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
No
Resolution:
200
Infill:
35
Filament: MatterHackers PLA Lt Blue Post-Printing =============
Used a heat gun to "open" the recess a little and gently set the magnets in with a non-ferrous tool (I used a bamboo skewer [very handy when dealing with magnets]). Lastly, I covered the magnets with instant glue to seal them in (just as an extra precaution).
Category: Household Supplies
Chip Clip remix
by Brian Hill · original on Printables ↗
Household / Other House Equipment
♥ 139⬇ 2.2k🖨 20 prints
Print profiles
Large_Clip_remix.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Small_Clip_remix.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Medium_Clip_remix.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print