An easy to print human skull cut into pieces that require minimal supports. If you print with snug supports on the build plate only then only a little of the underside of the nasal structure gets 'stringy' (above the roof of the mouth).
I reused the jaw parts from Peter completely unchanged. I printed both the jaw and skull at a 0.3mm layer height and was quite pleased with the results.
Human skull, anatomically correct - Re-Cut + snap-on jaw
by Gage · original on Printables ↗
Art & Design / Sculptures
♥ 6.5k⬇ 19.9k🖨 106 prints
Print profiles
jaw_lower.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
jaw_top.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
jaw_whole.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Updated Skull_Back with Peg Holes.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Skull_Face with Peg Holes - No Jaw Snap.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
v3_updated_skull_face - with Peg Holes and Snap.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print