This is another lipless rattletrap type crankbait I designed. This is a little different then a normal type lipless lure as I tried to make the body a little wider in hopes it would maybe dive a little deeper or have a different kind of action to it. I haven't fully been able to test it yet but it does swim straight.

More details about this design can be seen on my website at https://www.theneverendingprojectslist.com/fishingprojects/liplesscrankbait/

There are several different STL files... some are different sizes and others had different features. (see below for explanations.)

Enjoy.... and post some makes if you use these it lets me know I'm not wasting my time uploading my designs and if you like what you see check out more of my lures at https://www.theneverendingprojectslist.com/

Print Settings

Printer Brand:

MakerGear

Printer:

MakerGear M2

Rafts:

No

Supports:

No

Resolution:

.10

Infill:

80%

Custom Section

These are the sizes of the Small,Medium, and Large STL files. (there is no Ultra Light STL uploaded yet) The finished wieghts will depend on what you add for weights.

The S,M,L STL's all use tie on forms you have to bend from stainless steel wire.

The Lip_Less_Small_8.STL and Lip_Less_Photo.STL use Stainless Steel Sinker Eyes I found on amazon (https://www.amazon.com/gp/product/B00UQX4ING)

The Lip_Less_Photo.STL is a featureless blank that can be used for doing photo finishes. The Photo Finishing Technique I am trying can be found here https://www.theneverendingprojectslist.com/fishingprojects/photofinishtechnique/

Category: Sport & Outdoors