Rack/stand for 4x 3.5" HDDs. Print one for each side. I used fairly standard hard drive screws, found in basically any computer hardware store.
I added a flattened version to print laying flat, inspired by BrewKnell's make, which shortens print time significantly.
After seeing unklfrsh, I got pulled back into this design once again, and decided to make a version with slots for zip ties.
As I noticed that very few things in the design file were constrained to anything, I decided to remake it from scratch. So here is that, Version 2!
I decided to keep the old versions, just for posterity.
Happy printing!
External 3.5" HDD rack (UPDATED TO V2)
by Adalras · original on Printables ↗
Gadgets / Computers
♥ 178⬇ 1.1k🖨 6 prints
Print profiles
HDD rack (V1).3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
HDD rack_flattened (V1).3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
HDD Rack (V2).3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print