THIS IS A REMIX OF : https://cults3d.com/en/3d-model/art/sus-rock

sliced with cura 5.0.0

I had to print it sideways for best results(look at 2nd image). Printing it sideways reinforces the bond between the model end the keycap bottom

support overhang angle: 60

support placement: touching buildplate

keycap works for cherrymx type stem

the hole for the switch stem is a bit bigger than the actual stem. I had to make it that way otherwise it wouldnt fit(at least not with my printer which is calibrated). If it feels the hole is too big just put a piece of paper in it.