This is clicky rocker switch! Case and Spring parts are compatible with original “Fidget Clicking Wheel 2.0”.

Print Settings:

Material: PLA, PETG
Layer height: 0.15 - 0.20mm (For your information, I tested it at 0.30mm and it was quite tight due to the tolerance.)
Supports: no
Perimeters: 2

Assembly:

Before assembling, fit each wheel into its respective casing and ensure smooth rotation. If the rotation feels stiff, use a file to trim it as necessary.

Finally, set the spring and make sure the wheel is engaged, then attach the opposite side of the case.

Note:

I recommend that attempting to make a conversion from the original “Fidget Clicking Wheel 2.0” use the hard spring.
The feel varies greatly depending on the material, try it!

My Other Fidget Toys:
https://www.printables.com/@BaGooN/collections/1156349

Fidget Rocker Switch Clicker

by BaGooN · original on Printables ↗

Toys & Games / Other Toys & Games

♥ 563⬇ 3.1k🖨 102 prints

License: Creative Commons — Attribution ↗fidgettoyrockerswitchfidgetclickerfidgetswitch

Print profiles

SpringHard.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
RockerWheel_v3.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Case_C_v5.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print