This is meant to eliminate sag on the free end of your graphics card. The ones I found online were to flimsy for my taste so I made a bulkier assembly.
Start with the screw and loosely thread the nut onto it. Then add the sleeve and adjust the overall height. Once you are satisfied with the results, use the locking nut to fixate the sleeve.
The top should be printed in TPU and makes contact with the GPU itself.
Please keep in mind that I cannot take responsibility for any damages this causes on your computer, so use at  your own risk.
Printed with 3 walls and 20% infill, no supports
GPU graphics card anti-sag support
by Chewbugga · original on Printables ↗
Gadgets / Computers
♥ 73⬇ 948🖨 3 prints
Print profiles
220429_gpu_supp_nut.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
220429_gpu_supp_tpu_4mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
220427_gpu_supp_screw.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
220429_gpu_supp_top.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print