This Pokémon plant-pot has a lot of 3D surface detail and will decorate your window sill or sideboard or… every place!

Updated Version: STL #2 is modified with an optional drain hole. 
Still I'm marking this as a reupload since changes arent substancial.

Fits: 
Scale 60%: Every standard 5 cm plant pot. Best to plant a succulent or smal plant in it.
Scale 120%: Will fit to any “normal” sized plant pot with around 10 cm diameter.

Lore: Along with Charmander and Squirtle, Bulbasaur is one of three starter Pokémon of Kanto available at the beginning of Pokémon Red, Green, Blue, FireRed, and LeafGreen. 
Remark: This model was desined by littlebala and published under CC Attribution Non-Commercial Share Alike.

Printing Recommendations: 0.2 mm layer hight, 15 % infill, 3 perimeters.
The model prints well without supports, but expect a slightly rough 
surface around the front neck.

Feel free to share and like or just print a whole army of them ;-)

Want a cute watering can for your planter?
Klick here:
https://www.printables.com/de/model/254485-dodecahedron-watering-can