Printable accessory developed specifically to enable you move your Original Prusa Enclosure around easily. The handle is symmetrical, but you need to print 2 pieces.

Check the guide on how to install the Transport handles.

To mount both handles you will need the following fasteners*:

• 6x M3x12 screw (6x)
• 6x M3nS nut (6x)

* The package of the Original Prusa Enclosure includes extra fasteners, which were added in case you need to install the transport handles.

Print instructions

You have two options:

• use the pre-sliced G-code and print it on your MK3S+
• download the latest PrusaSlicer and use the following settings**:
  • print settings: 0.30mm DRAFT
  • filament: PETG (tested on Prusament)
  • 15% grid infill

** Note that print settings are recommended, but you can experiment with your own.