While there are a few designs out there to mount two fans on the back of the SSUPD Meshlicious, I wasn't really impressed with any of them, some have misaligned holes, and none of them accommodated two 50mm fans which I happened to have spares of.
I designed these brackets from scratch, but they were inspired by arwame's design here.
Use standard fan screws to mount the fans (make sure they're pushing air out of the case), and use the 3 included screws holding the PCIe brackets to mount the part to the case. I was able to screw from outside the case, by holding the bracket tight to the inside while I screwed in.
Meshlicious Rear Fan Bracket Mount 60mm & 50mm
by EddieCoast · original on Printables ↗
Gadgets / Computers
♥ 30⬇ 610🖨 1 prints
Print profiles
meshlicious_rearfan_50mm.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
meshlicious_rearfan_60mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print