Design highlights
- Uses minimal filament to print
- Prints fast (about 2 hours)
- Defaults to the optimal 12°
- Angle is fully adjustable with the feet
- Built-in bubble levelÂ
- Attached to the stand using the front tripod mount and the rear "thread stopped"
Print Guidelines
- Printed in PLA+
- Print with at 3 walls/perimeters
- Infill 15%
- No Supports required
Non-printed items
- Two M5x25mm bolts
- One M5x40mm bolt
- Bubble level 18mm diameter (search Aliexpress/eBay for “Round bubble level mini spirit level Bubble Bullseye”)
Note that the stand/base has been designed with M6 threads, but due to the accuracy of my printer M5 ended up fitting better after printing
FlightScope Mevo+ Stand (version 1)
by peter · original on Printables ↗
Sports & Outdoor / Indoor Sports
♥ 27⬇ 785🖨 0 prints
Print profiles
mevo_plus_stand.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
m5_bolt_cover.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
back_stopped_nut.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print