YAPH?! (yet another phone holder?!)

I needed a phone holder in my car to better read traffic information. This is what I came up with. Mostly as a design challenge since I just started printing, but works pretty well if I may say so.

Why is it special?

It's my first print-in-place model and I added some aesthetic trick in like the laminated look and the honeycomb pattern (because hexagons are the bestagons). It even locks in place when you fold it up so it doesn't flap about.

Printing tips

Check the attached gcode and 3mf for tips. As with every print in place model, please make sure that your first layer is tuned and not over extruding to prevent the first layer from fusing the hinges. Feel free to ask questions when you need to!