This is a remix of Ryan Millar's Honeycomb Display Shelf. However, the design was used as visual inspiration, I am unsure if they are dimensionally similar.

I wanted to add a new variation with a front panel.

Printing : PLA

Frame

Infill: 20% Gyroid

Layer height: .2mm

Supports: Support enforcers only. Snug style. V1.1 I found it best to support the angled bracers. shown in GCODE.

V2 I separated the angled brace and added alignment tabs with .12mm tolerance. I added supports for the alignment tabs on the angled brace and for the vertical alignment holes on the wall plate. Cuts down printing time significantly! The same infill plate can be used on version 1 and 2

Infill Plate

Easily customized!

Layer Height: .2mm

No supports needed if larger face is on plate.

Top/Bottom Layers: 0

Infill: I used honeycomb at 14%

Hex Wall Shelf Display

by KiloxTango · original on Printables ↗

Art & Design / Wall-mounted

♥ 246⬇ 910🖨 2 prints

License: Creative Commons — Attribution — Noncommercial ↗displayshelfwallmountstoragecoolhoneycombhex

Print profiles

Honeycomb Wall Display Infill v.1.1.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Hex Wall Display v.1.1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Honeycomb Wall Display v2.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Honeycomb Wall angle v2.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print