I designed this smaller foregrip a while ago for a pistol I was working on.

It is nearly vertical, at 83°.

Use a 6-32 x 1.25" bolt to mount the Picatinny.

The Mlok uses 2x 4mm x 20mm screws with mlok t-nuts.

Update 10/25/2022:

Added a Picatinny_V2 that is all one piece for sliding onto a rail.

Added the mlok STEP file as requested.

Increased the size of the picatinny cutout on the Picatinny versions as I found it too tight.

Angled Mini Foregrip

Sports & Outdoor / Outdoor Sports

♥ 133⬇ 1.3k🖨 6 prints

Print profiles

VertGrip-Angled-MLOK.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
VertGrip-Angled-PicatinnyV2.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
VertGrip-Angled-Picatinny02.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
VertGrip-Angled-Picatinny01.STLDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print