I was asked to print https://www.thingiverse.com/thing:2176304 but PrusaSlicer wouldn't correctly slice it. Instead I drew this in Fusion 360 based on the picture.

It printed nicely although maybe its a little small. Might be worth stretching in the X & Y directions.

The walls and floor are only 1mm thick. It's probably enough but the Fusion360 file is attached if you want to make anything thicker.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

180

Infill:

20

Filament: 3dk.berlin PLA Black

Notes:

My filament is old and brittle so I wasn't sure how well it would print. Apart from a bit of stringing it was fine though.

Category: Office