Hi everybody,

there are loads of cases for Arduino and even Wemos on thingiverse, but i decided to design some new, very specific for me.

My main intentions were:

• small packaged case
• tiny walls (yes a little fragile, but light weight and little print material usage)
• "clamping" of the wemos d1 mini board so it can not move
• no screws
• access to the I/O pins (through female header pins)

==== Dimensions ====

Outer Dimensions (LxWxH): 36,5mm x 28 mm x 12 mm

Inner Dimensions (LxW): 35,8 mm x 27 mm and standard "board height"

!! Very important !!!

I used wemos d1 mini boards from AZdelivery for experimenting and did the fitting according to their dimensions. Other manufacturers may have some slightly different dimensions (might fit as well). Please check your boards dimensions if they fit this design or vary just slightly. If you printed this design and fit a wemos from another manufacturer it would be nice if you could tell me so i can add them to the list.