Print with PETG, without support Z=0,3 20%infill
! Print Spring with 100% infill !
Simple to build together, but only one way is easy way. :)
How to put together:
In this step, I suggest placing a piece of cardboard between the jaws and pushing the upper part until the jaws are parallel.
Then push the spring until it clicks into place.
W
Strong CLIP attack
by Wilko_SLO · original on Printables ↗
Household / Kitchen
♥ 1.6k⬇ 11.2k🖨 132 prints
Print profiles
CLIP Second Part.stlIN STOCKDEFAULT
⏱ 18m · 8 g · 72 × 44 × 15 mm · 1 material(s)
Prints on: A1 mini 0.4PLA
Order this print
Spring.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
CLIP First Part.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print