I liked the original design by airbiscuity but the fitment was far too tight. I loosened the fit so the magazine will slide in and out easily but not fall during running. Secondly I changed the loops to be a belt clip that can be mounted to a belt without needing to feed the belt through, and added a version that hooks onto MOLLE to be mounted on a plate carrier.
The orientation of the belt clip requires printing the holder on its side. See figure 1. Enable supports everywhere, as seen in figure 2.
Figure 1. Required Printing Orientation
Figure 2. Enable Supports Everywhere
Category: Sport & OutdoorsAR15 Magazine Holder - Belt Clip and MOLLE versions
by Blargedy · original on Printables ↗
Sports & Outdoor / Outdoor Sports
♥ 119⬇ 766🖨 2 prints
Print profiles
M4MagHolderSlideDownBelt.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
M4MagHolderMolle.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print