one Foot is as big as the printbed from the MK3S so you can only print one at a time

It is not a perfekt fit but close enough and does the job gerat

I printed them with a 0.6mm Nozzle with 0.2 mm layerhight and 4 outer shells.

hope you like it^^

DE: Ein Fuss ist so gross wie die Druckfläche des MK3S, somit lässt sich nur ein Fuss auf einmal Drucken

Der Fuss ist nicht Perfekt aber macht seinen Job gut.

Ich habe mit einer 0.6mm Nozzle und einer Schichthöhe von 0.2mm gedruckt. Ausserdem habe ich noch die Aussenhülle mit 4 Layer gedruckt.

Hoffe du hast daran freude.

Playstation 5 (ps5) horizontal stand

Gadgets / Video Games

♥ 1.7k⬇ 20.3k🖨 70 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗standgamingplaystationfootdisk5sonydischorizontalhorizontalstandps5playstation5standfuss

Print profiles

PS5FootLeft.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PS5FootRight.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PS5FootRightNoLogo.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PS5FootLeftNoLogo.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print