This is a Cute Dragon figure. There are 2 versions available: vanilla and with already built-in supports. Supports were carefully added manually and thoroughly tested.
Recommended print settings
- layer height: 0.2 mm
- infill: 5% gyroid
- perimeters: 3
- supports: built-in
Scaling down model with supports is not recommended, because it may cause the supports to fail.
Since PrusaSlicer 2.6, organic supports can be generated automatically, so I recommend using it if there are problems printing version with built-in supports.
Cute Dragon
by kosteklvp · original on Printables ↗
Toys & Games / Action Figures & Statues
♥ 1.8k⬇ 12.5k🖨 272 prints
Print profiles
Cute Dragon.stlIN STOCKDEFAULT
⏱ 1h 6m · 25 g · 67 × 78 × 65 mm · 1 material(s)
Prints on: A1 mini 0.4PLA
Order this print
Cute Dragon.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print