This expands the usable diameter of the opening of the moon lamp base from <60mm to >70mm. I have included several adapters to fit two moon lamps as included below. Hopefully the screw thread bases make it easier to work the tolerances. One of my biggest complaints with the original design is that the tolerances were too tight, and I had to sand it down a lot.
I printed all pieces at 0.2mm, and they seem to work fine. I did not use supports at all, and the top of the moon did reasonably fine. I also added a brim, just to ensure that the reduced footprint would adhere to the bed, but it's possible you may not need it.
https://www.amazon.com/dp/B00CM5SVU2/
This one has the smaller “candelabra” bulb, which fits the “wide_base_cap” adapter.
https://www.amazon.com/dp/B0983887RK/
This one has the standard medium bulb, which fits the “xxx_36mm” adapters.Â
Lithophane Moon Lamp with Wide Screw Base
by The QuickSilver · original on Printables ↗
Household / Home Decor
♥ 235⬇ 1.7k🖨 13 prints
Print profiles
moon-globe-mk3-screw.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
wide_base_cap.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
funnel_cap_36mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
wide_base_cap_36mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
wide_base_cap_40mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print