230102: Added Base and Roof with slightly bigger tolerance since some had issues with the fit being too tight, Original parts have 0.5mm overall, parts with increased tolerance has 1mm overall.

Base and Frame printed in 0.2 with 15% infill. Roof printed in 0.1 with 15% Infill.

Support needed on the Base.

The base has a 29mm hole to put a lightsource through, I use an E14 LED-Lamp.

I recommend using SuperSlicer, enabling only One Permiter on first layer aswell as Hilbert Curve pattern on the bottom layer for a good looking surface on the base as the printed bottom will be upwards when assembled.

Lithophane Lamp

by Wiikendz · original on Printables ↗

Household / Home Decor

♥ 672⬇ 2.9k🖨 25 prints

License: Creative Commons — Attribution — Noncommercial ↗lamplithophane

Print profiles

Base.STLDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Roof.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Frame.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Base Slightly Bigger Tolerance.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Roof Slightly Bigger Tolerance.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print