After printing:

press the rotor into the housing - it should jam until completely in where it must turn freely.

If you could press in without resistance there is danger to aspirate the rotor when inhale!.

alternative: you can also use it like a side-blown western concert flute and blow over the slits.

High speed turbo whistle

Toys & Games / Other Toys & Games

♥ 86⬇ 1.3k🖨 2 prints

Print profiles

22-167Sirene.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
22-167SireneDUO.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
22-167SireneDUO8-6.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
22-167SireneDUO8-5.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
22-167Sirene2.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print