A bike bottle holder for your standard 0.5l PET bottle. The holder is designed with harder use in mind and therefor not too thin.

There are two different versions. One with slots at the side and one without them.

Check the measurements to find out if your bottle and bike will fit.

Measurements:

height: 129.5 mm
diameter of the hole: 69 mm
diameter of the frame: up to 33 mm
screws: M5

Print Settings:

Supports: (usually) no
Raft: doesn't matter
Walls: 3
Infill: at least 20%
Material:
- PLA works
- PETG or ABS/ASA might be even better

About the slots:

They make the print a bit lighter. But also a bit less sturdy. They can also increase the print time, as the supports that are needed if you choose the version with the slots on the side may take a bit longer to print.

About v3

I changed the mounting mechanism, so it can fit different spacing between the holes in your bike frame. I also made the slot's diameter a bit wider, as the screws fitting were very tight.

If you are interested in a different size or other changes, just leave me a message and will see if I find time to make it.

Bike Bottle Holder

by jo2801 · original on Printables ↗

Sports & Outdoor / Outdoor Sports

♥ 122⬇ 752🖨 12 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗bottleholderbicyclebikeebikemountainbikeflaschebottleholderfahrradflaschenhalterpetbottlelitrefahrradhalter

Print profiles

bottleholder_0-5petV2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
bottleholder_0-5petV1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
bottleholder_0-5petV2.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
bottleholder_0-5petV1.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
flaschenahlter_0.5lpet v3 v5.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
flaschenahlter_0.5lpet v3 v5.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print