It's a guitar! You can either put a 10x1mm magnet in the back of the guitar, or some small ones in the hole on the front.
Print with supports, and add in a support blocker on the back.
If you have a dual extruder setup, I'd highly recommend that you print it using that, as it will give much higher quality results.
Mini Guitar
by jumpshawt · original on Printables ↗
Hobby & Makers / Music
♥ 104⬇ 899🖨 6 prints
Print profiles
Color A.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Color B.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Guitar.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print