This is a remake of something I found on Thingiverse. Unfortunately, I can't find it again to give that person credit. The original was slightly too big to print on an Ender 3. Since scaling will not work, I had to re-do this from the beginning. I like this setup because it utilizes vertical wall space much more efficiently than storing the cans vertically or horizontally against the wall. As usual my Fusion 360 files are included as is a .odt file further discussing this project.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.12mm
Infill:
50
Filament: Hatchbox PLA Black
Notes:
Used Cura 4.12.1 with tree supports.
Category: GadgetsSpray Paint Can Holder
by Jim 248 · original on Printables ↗
Gadgets / Other Gadgets
♥ 296⬇ 1.6k🖨 9 prints
Print profiles
Right_Bottom_0.15.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Left_Bottom_0.15.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Left_side_0.15.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Right_Side_0.15.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print