Phone charging dock. It was made to fit Type C cable. Little bit of hot glue will be needed for securing cable in place. Type C connector fits pretty snug so no glue needed there.

I recommend to use sticky pads under the phone charging dock. That way you will be able to take phone from the dock just using one hand and if needed sticky pad can just peel off and reuse it again in different location.

Print Settings

Rafts:

Supports:

Doesn't Matter

Resolution:

0.2

Infill:

Filament: Spectrum PLA Star dust blue

Phone charging dock

by JustIPrints · original on Printables ↗

Gadgets / Portable Devices

♥ 87⬇ 1.2k🖨 5 prints

License: Creative Commons — Attribution — Share Alike ↗phonestandchargerphonechargingsmartphonesmartphoneholdersmartphonestandmobilechargingdockqichargerthingiversechargingstationmobilephoneholdermobilephonestandchargingstandusbchargerusbtypec

Print profiles

Phone charging dock.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print