I downloaded Mickey Mouse for $5 on this website, but I only wanted the hand so I could make it into one of the pointer finger sticks. I've designes it so that you can slide it onto a bic pen.

Here's the original model: http://www.designsharemake.com/design/mickey-mouse

Print Settings

Printer:

Wanhao Duplicator i3 V2.1

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2 mm

Infill:

20%

Notes:

Printed in Wanhao black PLA
Temp: 215 C

Bed: 60 C

Print time: Around 1.5 hours

Slicer: Simplify3d

NOTE: Support material is not necessary in the hole on the bottom. Simplify3D and Craftware offer customizable support, but if you don't have those, i've included the supports from S3D in the files.

Category: Sculptures