An inexpensive clip for cage/string training tomato plants or other garden plants. Designed to be printed in PETG or other outdoor-friendly filaments, the 100% size is ~25mm in diameter once printed and clipped closed, and can hold tight on the hinge side to a twine/string to hold itself in place if you're not using tomato cages. 

Also included is a pre-scaled 150% version, which prints at ~35mm in diameter and is suitable for larger vines or for clipping against vertical posts or wire tomato cages. 

Version 7 model updates: 

• Tighter tolerances on the clasp for more holding power, 
• Stronger design around the male and female ends of the latch, and
• Reduced need for supports on the male end of the latching mechanism for better consistency in print quality

Photo above shows:

• 150% version (using original v4 model)
• Printed in purple MH Build PETG, 
• 0.2mm layer height
• Supports on, due to the offset of the male end