Vertical foregrips for 1913 rails modeled after the KAC VFG. No bolts needed, just align the grip body on the rail and tighten the grip screw.

Print 1 standard or stubby grip body, and 1 respective screw.

Print Orientation

The STLs are oriented in the correct position (upright for screw, face down for grip body). Orienting the grip body this way will only require supports for a single overhang.

Hardware

1" o-ring (identical to KAC VFG o-ring). May be optional, but I haven't tested if the screw would loosen any faster under use without it.

Settings

Material: PLA+
Nozzle: .4mm
Layer height: .12mm
First layer height: .2mm
Perimeters: 5
Infill: 100% (may not be necessary, but why risk it)
Hotend: 225°
Bed: 60°
Supports: Only required for grip body, not screw. On buildplate only. Supports needed for initial overhang of 1913 interface.

1913 Broomstick Grips

by commandqueue · original on Printables ↗

Sports & Outdoor / Outdoor Sports

♥ 44⬇ 852🖨 1 prints

License: Creative Commons — Attribution ↗

Print profiles

broomstick_screw_standard.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
broomstick_screw_stubby.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
broomstick_body_stubby.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
broomstick_body_standard.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print