A very sturdy and clean design i made of a holder that clips on to my Xbox Series X to hold the Controller and Headset.
The X infill is a seperate file and can (ofcause) be printed in various colors to match your style. You might have to print the X a little smaller like 98%-99% to make a better fit.
Since theres a lot of overhangs i would advice to use supports custom or everywhere.
I also included two diffrent holders, one with just an “X” and another one with the traditional “Series X” logo.
USING A HEAT RESISTANT MATERIAL IS STRONGLY ADVISED!
Like ASA or PETG, since the holder is placed above the heat exhaust!
Xbox Series X Headset and Controller holder
by Fuffenstein · original on Printables ↗
Gadgets / Video Games
♥ 184⬇ 1.2k🖨 11 prints
Print profiles
SeriesX_Holder.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
SeriesX_Holder.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Holder_Series_X.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print