Designed a simple pokeball. Features a magnetic latch and uses a filament based hinge
Needed quantities of parts:
2ea Lids
1ea Top_Body
1ea Bottom_Body
1ea Button
12ea Nubbins
14ea Nubbin_Tips
Additional Parts
2ea 4x2 neodymium magnets
small length of 1.75mm filament
Assembly:
press in magnets to body halves
Use superglue to attach button to top body
use hot glue to attach lids to bodies
assembly hinge with 1.75mm filament
nubbins glue to where there is holes in body halves (intent for holes was to use filament to attach but I left them for a locational guide.)
Nubbin tips are glued to Nubbins.
Enjoy!
Pokeball
by krispykashew · original on Printables ↗
Costumes & Accessories / Props
♥ 588⬇ 1.8k🖨 14 prints
Print profiles
Button.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Nubbin.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Nubbin_tip.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Lid.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Top_body.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Bottom_Body.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print