**9/26/22** Updated model that uses 4mm screws with larger hinges and a small insert for an SD card in the top shell. Enjoy!
Might revise the hinges since they seem like a weak point. I needed to drill the holes out a bit but other than that everything was an easy fit. To get the colored text, I printed using .2mm layer height and printed the text first. When it finished, I immediately ran the top lid right on the same spot without removing the text. The heights should line up just right to form a clean first layer but your tolerances may require some fiddling with settings. The video I followed for that trick is below.
Flipper Zero Case
by TruTech · original on Printables ↗
Gadgets / Portable Devices
♥ 1.0k⬇ 7.6k🖨 71 prints
Print profiles
flipper_box_text.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
flipper_box_Clip.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
flipper_box_Bottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
flipper_box_Top.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Flipper_Box_Hinge_4mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Flipper_Box_Bottom_4mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Flipper_Box_Top_4mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print