A set of covers for a straight-through XT60 connection (mainly so I can avoid shrink tubing).
Has 2 separate 4mm diameter wire holes. The fit is a bit loose but suits my requirements.
I printed on a raft - without one, you may need to cut some of the inner edge to fit the connector. Note that not all connector brands may be the same.
No supports needed.
SAFETY: Please please keep in mind that you should solder your connectors really well. With these covers you won't be able to see if the wire might have come loose inside - so it is probably still safer to individually heat shrink the connections, especially if you are sending a lot of unfused current down them.
How I Designed This
Fusion360 - Drawings, Extrusions, Offset Planes, 1 Loft Extrude + 2 Loft Cuts, Edge Radius
Drawings, Extrusions, Offset Planes, 1 Loft Extrude + 2 Loft Cuts, Edge Radius
Category: R/C VehiclesXT60 Plug Housings
by timkrins · original on Printables ↗
Hobby & Makers / RC & Robotics
♥ 276⬇ 1.6k🖨 23 prints
Print profiles
XT60_Housing_F.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
XT60_Housing_M.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print