Following the example set by nemokeine the holes in these have been enlarged from 3mm to 4mm for an easier time getting the 95 paracord through armourcraft's models.

95 paracord is thinner than the more widely know 550 paracord.

Shown pictured with 6.25" pieces of 95 paracord tied into a loop for looping through one zipper hole and an 8.5" piece tied in a loop for looping through two zipper holes.

Printed here in ASA, but other materials should work too.

Print Settings

Rafts:

Supports:

Resolution:

0.16

Infill:

0.5

Notes:

printing one at a time caused layer sagging that appeared to be from insufficient cooling time between layers. Printing ten at a time did not have that same issue.

Remixed from
https://www.thingiverse.com/thing:2964645
https://www.thingiverse.com/thing:3123461

Category: Accessories

95 Paracord Zipper Pulls

by PenguinFeet · original on Printables ↗

Fashion / Other Fashion Accessories

♥ 277⬇ 931🖨 20 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗baggripdonglethingiversezipperglovesknotbeadzipperpullzippertabdangle

Print profiles

Zipper_Pulls_aerodynamic.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
zipper_pull_kurled_mini.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Zipper_Pulls_barrel_mini.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Zipper_Pulls_barrel.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Zipper_Pulls_aerodynamic_mini.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Zipper_Pulls_waterdrop.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Zipper_Pulls_knurled.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print