Since the included wall mount of the Dyson V12 Slim only has room for two accessories, I built myself additional wall mounts.
I mounted the wall mounts with tesa Powerstrips. But they can also be screwed. The larger hole is to get with the screwdriver to the screw.
Depending on the accessories, the distance to the wall must be slightly larger. There is a holder with 20mm and one with 40mm distance to the wall. The beveled 40mm holder is for the Dyson "low-reach adaptor", as this is slightly higher at the back than at the front.
I printed everything in PLA with 0.2mm.
Dyson V12 Slim accessories wall mount
by MM Bavaria · original on Printables ↗
Household / Other House Equipment
♥ 213⬇ 1.7k🖨 17 prints
Print profiles
40mm bevelled.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
40mm.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
20mm.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print