Needed a way to discretely store my rifles in a locked closet. The walls are rather soft, so I didn't want them leaning on the drywall--scratching the walls and getting dust everywhere.

This mount allows the rifle to mounted vertically or horizontally. There is a groove on either side that engages the magazine catch to secure the rifle muzzle up, muzzle down, left, or right..

You may need to scale it up by 2540%. Designed in inches, most slicers use mm. STLs are unitless.

Print Settings

Printer:

Qidi Tech 1

Rafts:

Doesn't Matter

Supports:

No

Resolution:

.2 to .3

Infill:

20%

Filament:

Cheapo ABS or PLA

Any

Notes:

You'll note a gusset on one end of the part. This part should be toward the bed. It adds a little stiffness to the print and provides more surface area for bed adhesion.

Post-Printing =============

Mounting

There are six holes present on the model. I used cheap walmart wall anchors and would suggest using at least 3 of the six holes to mount it. Two on one side, one on the other.

Category: Sport & Outdoors