Some test files to adjust your settings to get the perfect first layer. These will print 1 layer provided you are using a 0.2 mm layer height in your slicer settings. Then inspect your print and tweak one setting at a time until you get a perfect first layer as that is the most important layer.
Once you get a good result with the simple shapes, try the extreme test. If you can get that to print without any gaps, then you have a perfect first layer.
Print Settings
Printer:
Creality CR-10
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
None
How I Designed This
Fusion 360
Category: 3D Printing TestsFirst Layer Test
by mikeneron · original on Printables ↗
3D Printers / Test Models
♥ 123⬇ 13.1k🖨 13 prints
Print profiles
First_Layer_Hex_0.2.stlIN STOCKDEFAULT
⏱ 3m · 1 g · 81 × 70 × 0 mm · 1 material(s)
Prints on: A1 mini 0.4PLA
Order this print
First_Layer_Oval_0.2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
First_Layer_Extreme_Test.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
First_Layer_Circle_0.2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
First_Layer_Square_0.2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
First_Layer_Octo_0.2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print