Designed a chair wheel or castor stopper so that I could still use my chair to play racing simulators. The wheels are 60mm diameter and 54mm width (60mm x 54mm). The chair I'm using is an Ergochair ripoff, so you shouldn't need to remix this if you have it or have a wheel size that's smaller than 60mm x 54mm. I used some rubber feet at the bottom. However, I have designed a simple feet that you should print in TPU if that's what you fancy. And of course, would definitely recommend printing the TPU feet in 100% infill. Overall, it works wonderfully well! Do post a make if you decide to print one :)

Print Settings

Printer:

Creality Ender 3

Infill:

10

Filament: Smith3D PLA+ Yellow

Notes:

From my experience so far, 10% cubic infill on Cura is sufficient. For the perimeters, I used 4.

Category: Office