This is a remix of Cmdr_Falken's design (https://www.thingiverse.com/thing:4393430). Huge thank you to the original design!
I decided to break the original design into three rather than two pieces, reducing the need for supports. The insert fits into the cup holder built into the pump. The magnets allow for the holder and bottles to be stored in the fridge; we would put the holder in a gallon sized bag. The magnets hold everything in place during use. When we needed to store the bottles, it could be lifted from the holder without need to mechanically detach anything.
Assembly:
1x M5 bolt (20mm or less)
6x 8x3mm round/coin magnets (an example here)
Use bolt to connect Insert and Magnetic Mount.
Reverse one magnet pair, if you want it to orient in only one direction rather than reversibly
Spectra Bottle Holder
by Thrasymack · original on Printables ↗
Healthcare / Home Medical Tools
♥ 53⬇ 746🖨 4 prints
Print profiles
Insert.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Bottle Holders.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Magnetic Mount.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print