This is a remix of "Waveshare display (v1/v2) with a PiSugar 1200mAh battery and a carabiner loop" to support the PiSugar2 1200mAh (switched USB charging port/button, and added a slot for the power switch).

I made the case and lid a little "fatter" to better support the PiSugar2 (only 1mm, but it made a world of difference), and added heat dissipation slots in the lid, and I've also included a slightly larger button (the original "slipped" a little sideways when I tried using it).

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

Supports:

Resolution:

0.15

Infill:

15%

Filament: Filamentive PETG Orange

Notes:

To get an interference fit on the lid, I needed to make it a little larger than "as supplied"; height was fine, but needed 0.5mm added to width and length). YMMV.

Category: Gadgets

Pwnagotchi Case

by PantsManUK · original on Printables ↗

Gadgets / Other Gadgets

♥ 47⬇ 757🖨 3 prints

License: Creative Commons — Attribution ↗thingiverse

Print profiles

Case_WS_PiSugar2_1200.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Lid_PiSugar2_1200_1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Button_PiSugar_2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print