A remix from @Maniac1st https://www.thingiverse.com/thing:4786948/files with the following changes:

• Enlarged to snuggly fit a 43mm diameter spool hub.
• Changed to stopper pinch type instead of the need to bend frames while fitting paper towels.
• Shortened the cutter as an optional detachable clip-on (screws no longer needed) to fit a 230mm length spool hub.

Misc:

• Print both parts number 1 and 2 twice, then the optional cutter part number 3 once if required.
• The cutter can be printed on a 230mm bed else align the cutter 45 degrees to the bed also take note of its flat surface.
• The cutter has been modified to fit loosely in the holder slot and should not fall off or removed easily. But if the printing is not perfect that you have difficulties gliding the sheets between the openings, just force the cutter holes into the holder circle tabs. To install, face the cutter's flat side to the front with its saw like edges downwards, rotate the cutter 90 degrees side-by-side "parallel" to the holder, slide the thinner edge into the holder slot then rotate it back into "perpendicular" position. Do the same for the other side.

Print Settings

Supports:

No

Resolution:

0.28mm

Infill:

20%

Filament:

NA PET-G/PLA Category: Household