Remixed from Laci_Legath's Eye of agamotto
Changes
- Ran the models through OpenSCAD to fit my parts. Â
- Added screw posts and holes.Â
- Designed a new back plate to fit the battery holder.
- Designed a new jewel with a pentagram pattern.
There is also a peg for a pushbutton that I ended up not using. Â I ran the math on the single LED and came up with ~2 weeks of battery life.
Hardware
- Hot Melt Inserts: Length 6mm, M3, OD 4.2mm
- Screws: M3 8mm
- 6V CR2032 Coin Cell Battery Holder
- 500 ohm resistor
- 3mm Green Breathing / Fading LED
Finishing
Started with a coat of sandable primer, then brushed on bronze paint. Â Top coat is a wash of diluted black paint.
I used glazing spot putty (bondo) on the cage cover, then sanded smooth.
Eye of agamotto
by thatdecade · original on Printables ↗
Costumes & Accessories / Cosplay & Costumes in general
♥ 276⬇ 593🖨 12 prints
Print profiles
jewel-1-led.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
jewel-6-leds.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
eye_agamotto_base.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
eye_agamotto_battery_lid.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
eye_agamotto_cage_cover.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print