I found the original difficult to print as the logo was protruding so it could not be printed with the top of the lid face down. I wasn't particularly bothered about the design so I removed it.
There is also an alternative design which is recessed where the glass meets the lid where you can place an o-ring which I have also included. This helps to create a better seal.
Finally I have included a cutting guide for grease proof paper or whatever other material you wish to use to seal against the top of the glass as PLA/TPU is neither airtight or food safe.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.16mm
Infill:
20%
Notes:
Lid can be printed in any material.
The o-ring should be printed in TPU. It is designed to be an almost exact fit and you might find it a bit loose. If your TPU is quite stretchy you can scale it down in size a little for a better fit.
Category: ContainersMason Jar Lid
by GBlades · original on Printables ↗
Household / Other House Equipment
♥ 272⬇ 2.3k🖨 15 prints
Print profiles
Mason_Jar_O-Ring.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Mason_Jar_Lid_with_recess.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Mason_Jar_Lid.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Cutting_Guide.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print