Articulated Chameleon with movable eyes!!

Interchangeable jaw, with or without a tongue. You choose!!

No supports required. Just slice and print!!

Check my other articulated designs HERE!

Print Settings

Printer Brand:

Creality

Printer:

Ender 5

Rafts:

No

Supports:

No

Resolution:

0.16 mm

Infill:

0%

Filament: Several PLA All of them

Notes:

Depending on your printer and slicer, the fit of the "jaw" or "jaw+tongue" with the head may be too loose or too tight. You can print them a bit smaller or larger with no problems (recommended from 95% to 105%, but can be even more).

Post-Printing =============

Eyes

After printing, push the eyes until you hear a "click" or "pop" sound. That means now they are free to rotate. It may be hard to move the eyes at the beginning, but they become more free with the use.

Jaw / Jaw+Tongue

Depending on your printer and slicer, the fit with the head may be too loose or too tight. You can print them a bit smaller or larger as indicated above, or:

• If the tab is too tight, sand it a little bit.
• If the tab is too loose, you can "heat and squeeze" it to achieve a better fit. A hairdryer or even a lighter may do the job, and then press lightly with some pliers.

Category: Toys & Games