This is basically what Zack mentioned in the video.
I attached the Fusion360 file so you can go nuts with it.
This upload contais a 1x3 and 1x2 Model.
Update 2023-01-04:
Added versions without the magnetholes in the bottom, because its uses less material and prints faster. If you dont plan on using magnets, use the version without holes.
Credit go to
DrDflo: https://thangs.com/designer/DrDflo/3d-model/Engineer's%20Desk%20Organizer-37318
Zack Freedman for the open source design of the #Gridfinity https://thangs.com/designer/ZackFreedman
Gridfinity SD Card Holder (MicroSD Usb A and C)
by Marius · original on Printables ↗
Hobby & Makers / Organizers
♥ 367⬇ 2.6k🖨 82 prints
Print profiles
SDCard_MicroSD_USB-C Holder 1x2.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
SDCard_MicroSD_USB-C Holder 1x3.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
SDCard_MicroSD_USB-C Holder 1x2 (no holes).3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
SDCard_MicroSD_USB-C Holder 1x3 (no holes).3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print