This set includes two ramps and a trestle style support for building elevated tracks. The ramps are a bit too steep so most trains with scrape a bit when going up or down. But I wanted to make the ramps tall enough that trains could fit underneath them and this is the best I could do with the Prusa Mini bed size. Perhaps the next iteration will have a two-part ramp at a lower angle.
All parts can print without supports. No issues at all with the ramps. The trestle supports can be a little tricky. Printing them one at a time and using a brim around each foot I've had good success. I tried to print two at a time without any brim and had some failures.
Brio/Ikea Elevated Train Track Set
by rclauss · original on Printables ↗
Toys & Games / Vehicles
♥ 482⬇ 2.7k🖨 39 prints
Print profiles
train ramp 2.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
train ramp 1.STLDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
train trestle.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print