A much-improved version of my original VMU cap replacement that's about 95% accurate to the official Sega cap. I meticulously measured every little detail to make sure it fits perfectly, and it does! Visually it's not a 1:1 copy but it looks very close.

There are two versions available to print:

vmu-cap: Regular version. Should be printed right-side up with supports under the arches as shown below.

vmu-cap-flat-top: Easy-to-print “flat top” version. The flat top version can be printed upside-down easily without supports. 

Either one you choose, bed adhesion is very important. If any part of it lifts off the bed (warps) even a little bit, the cap won't fit right.

Be sure to post your makes! If you like the design, please consider tipping on Ko-fi. Thank you! :-)