Jewellery Tree ,Hang jewellery from branches ,branches have holes for ear rings etc .Tray for smaller bits .Tree and cat glued to tray.Tray has recesses underneath to add weight ,stops unit falling over.I glued steel into recesses 55mm x 19mm x 6mm ,covered over with filler then painted.Painted tree with two shades of brown to look like wood.

Print Settings

Printer Brand:

MakerBot

Printer:

MakerBot Replicator (5th Generation)

Rafts:

Yes

Supports:

Yes

Resolution:

0.2

Infill:

Category: Jewelry

Jewellery Tree

by Clive Harris · original on Printables ↗

Fashion / Women

♥ 264⬇ 969🖨 13 prints

License: Creative Commons — Attribution ↗jewelryartthingiversejewellery

Print profiles

Jewellery_Tree_Tray_no_weight_holes_in_bottom.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Jewellery_Tree_Cat.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Jewellery_Tree.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Jewellery_TreeTray.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print